Spinning·5 min read
How to choose the right traveller for your ring spinning frame
Weight, profile, wire section and finish. The four factors that decide traveller life and yarn quality.
The traveller is one of the smallest parts on a ring spinning frame, yet one of the most influential on end breaks, hairiness and energy consumption. Choosing it well is not a catalogue exercise: it is a process decision.
1. Weight (traveller number)
Weight sets yarn tension during winding. A traveller that is too light produces unstable balloons and breaks; one that is too heavy increases tension, hairiness and ring wear.
The practical rule is to start from the manufacturer’s recommendation for the count being spun and fine-tune on the floor by tracking end breaks per 1,000 spindle hours.
2. Profile and ring
The traveller profile must match the ring flange type. An incompatible profile causes irregular contact, heat and ring marks that will later affect every new traveller.
3. Wire section
- Flat section: larger contact area with the yarn, suited to fine counts and high speeds.
- Half-round or round section: more forgiving with coarse counts or synthetic fibres.
4. Surface finish
Surface treatments reduce friction and extend service life. They are especially useful for polyester blends or at high spindle speeds.
Signs it is time to replace
- A sustained increase in breaks within the same machine section.
- Yarn with higher hairiness or shiny marks.
- Travellers flying off or showing heat discolouration.
NOVERIX tip: always replace travellers by complete sections and log the date. Mixing new and used travellers on the same frame makes any later diagnosis much harder.
Tell us the frame model, ring type and yarn count, and our technical team will suggest the right part number plus a compatible alternative.
Written with AI assistance and reviewed by our technical team.
Need this part?
Browse the catalogue or send us the part number and we will reply within 24 hours.