Weaving·4 min read
Rapier grippers: five signs of wear you should not ignore
How to spot gripper and tape wear on rapier looms early and plan replacement before production stops.
On a rapier loom, weft transfer happens hundreds of times per minute. When a gripper starts to fail, the problem is rarely sudden: it gives warnings. Reading them is the difference between a planned replacement and an idle machine.
1. Missed picks or loose weft
If stops for non-inserted weft increase, first check the clamping pressure of the carrier gripper. A fatigued spring reduces grip, especially with smooth or synthetic yarns.
2. Wear on the tip and transfer zone
Shiny marks or rounded edges in the transfer zone mean the handover between carrier and receiver grippers is no longer precise.
3. Cracked or deformed tape
The tape works under constant bending. Micro-cracks around the drive holes anticipate breakage. Always replace the tape and inspect the sprocket wheel at the same time.
4. Noise or vibration at shed entry
A change in the loom’s sound is often the first symptom, usually caused by worn guides or a gripper rubbing along its path.
5. Fluff build-up
Not wear in itself, but it speeds wear up. A weekly clean of grippers and guides noticeably extends their life.
Recommended maintenance plan
| Frequency | Action |
|---|---|
| Weekly | Clean grippers, guides and tapes |
| Monthly | Visual check of tips and springs |
| Per manufacturer hours | Preventive replacement in pairs |
NOVERIX tip: always keep one complete pair (right and left) per loom model in stock. It is the cheapest way to avoid a long stoppage.
Written with AI assistance and reviewed by our technical team.
Need this part?
Browse the catalogue or send us the part number and we will reply within 24 hours.